Holly Necklace & Earrings


Ann Bernklau

Get all the major supplies needed to make this project with the Holly Set or you can order them separately.

Holly Necklace & Earrings
By Ann Bernklau


Click to Enlarge
 
Click to Enlarge

Designer Tips: Make sure your transfer image is glued flat to the jewelry before adding Diamond Glaze to avoid bubbles under the surface. Using the transparent transfers directly on the metal Patera jewelry gives it a silvery metallic look.

Supplies:

Instructions:

  1. Cut out the bird & holly oval from the transfer sheet. Trim to fit inside the 3/4x1 1/4 pendant (the corners may not be filled but they will be covered later). Cut out one of the small Santa circles as a template for the earrings. Trace the circle over the two rectangle holly images and cut out. Make sure all pieces fit flat inside the jewelry.
  2. Place the pieces in water for about 30 seconds. Remove and dab dry with a paper towel. Glue down the pieces inside the jewelry with a little bit of glue stick.
  3. For the necklace, add four small corner Dazzles™. For the earrings, trim off tiny swirl Dazzles with an X-acto® knife and add 3 swirls to each earring around the holly berries. Lay all pieces flat and fill with Diamond Glaze; let dry overnight.
  4. Add 3 red crystals to the center of each earring. Add 6 crystals to the pendant as shown. Attach a silver chain to the pendant.