Thank You Card
By LeNae Gerig
Designer Tip: Use stencil page to tape the brass stencil in place to prevent slipping while using the Cool Tool. Use the Cool Tool with a heat resistant surface like a ceramic tile or glass.
- Place the card fold at the top. Cut the card to 4"x6" and cover with brown/blue swirl paper.
- Place the ivory Paper Tex onto a heat resistant surface, place the template on top and secure the corners with tape. Place the fine point tip on the Cool Tool and allow to pre-heat. Slowly run the hot tip around the edges of the template inside and outer edges. Remove the tape and turn around the corners.
- Tear the teal glimmer paper to 1/8" larger than the template size and glue the burned image to the center. Glue to the card front, 3/8" from the top edge.
- Place a Pebble at the center and place the "Thank You" Dazzles( at the bottom.