Make A Wish
By LeNae Gerig
Designer’s Tip: When misting the card front with Glimmer Mist, place it on a covered surface then mist over the paper and let the mist fall on the card.
- Fold the Zig Zag card with the square window at the front and the fold on the left side. Apply Lavender ink to the card front and the edges of the Circle Laser Cut Card Layer. Mist both the card front and the Laser Cut Card Layer with Dragonfly Glimmer Mist and let dry.
- Cover the card back with Fancy Feathers aqua swirl paper and glue the Circle Laser Cut Card Layer to the center. Close the card and glue clusters of pink/purple buttons, flowers and rhinestones on the top and bottom corners as shown.
- Place lengths of Purple Jewel Border Dazzles™ along the square window and foam tape the “on point” square Flower Fairies Papier Tole off set to the left as shown. Glue dark pink rhinestones on the window corners as shown.
- Layer Papier Tole pieces with foam tape and place Gold Tiny Words & Phrases Dazzles™ “Make a Wish” as shown. Place Papier Tole corners on the top and bottom corners as shown. Hold 1/2” wide green sheer swirl ribbon and purple grid Fancy Feathers ribbons together as one and tie a bow. Zot(the bow onto the fold as shown.