Fall Look Week of Webisodes is live!
 

Share this:



Trick or Treat Card


Gail Booth

Trick or Treat Card
By Gail Booth


Click to Enlarge

Designer Tip: Cover your card front with torn Halloween papers. Ink the edges of a ½” strip of striped paper and glue at an angle on the left. Glue the “Trick or Treat” die-cut border ¼” from the bottom and cut even with the sides. Cut out the three tag words for the “post” and cut a “v” at the right end of each, then ink the edges. Zot™ a small fold of ribbon under the left end of each tag and Zot™ in place on the “post”, as shown. Zot™ a bow below the tags and foam tape the pumpkin die-cut as shown. Tie a loop of ribbon at the top of a small dotted frame and foam tape in place, as shown. Slip a Jack-O-Lantern die-cut into the frame at an angle and foam tape in place foam tape the “Trick-or-Treat” die-cut in place.

Supplies: