Share this:



Peace


LeNae Gerig

Peace
By LeNae Gerig


Click to Enlarge

Click to Enlarge

Designer's Tip: When applying a thick layer of embossing powder to tinsel, I like to heat from the bottom to prevent the heat gun from blowing away loose glitter elements.

Supplies:

Instructions:

  1. Place the card fold on the left and cover the front with Fresh Frost dark blue paper. Use an X-acto knife to cut around the left side of the die-cut snowflake. Ink edges of 1" wide strip of blue stripe paper and glue down the left side of the card, " from the edge. Embellish border with Silver Jewel Border Dazzles as shown.
  2. Place the large snowflake die-cut on scrap paper and cover with VersaMark using the surface of the stamp pad as the applicator. Sprinkle with Silver Embossing powder and Spoonful of Silver glitter mix. Heat snowflake from the bottom to prevent the glitter from flying away. Foam tape the snowflake over the snowflake on the card front. Embellish with Teal Jewel Dazzles as shown.
  3. Inside: Cover the card with Fresh Frost teal snowflake paper and ink edges black. Place a length of Silver Jewel Border Dazzles down the right side, 1/8" from the edge.
  4. Apply VersaMark to the medium snowflake die-cut and sprinkle with silver embossing powder and sprinkle with silver glitter and heat from the die-cut bottom. Glue to the card, aligning from inside the die cut center window. Apply VersaMark to the tiny snowflake die-cut and sprinkle with calypso glitter embossing powder. Foam tape the tiny snowflake to the center of the silver snowflake. Place Tiny Christmas Words Dazzles Black "Peace" on the card lower right corner.