Project comments (0) | Write a comment

You & Me Album

Gail Booth

You & Me Album
By Gail Booth


Click to Enlarge

Designer Tip: Layer papers and tapes behind the "Peek-a-Boo" transparencies.

Supplies:

Instructions:

  1. Remove the posts and album pages from your album. Ink the edges, binding, front and back covers by roughly swiping with the Berries ink pad.
  2. Place your album with the binding on the left. Tear the edges of a black dot paper to create two 2 1/2" squares and glue 1/2" from upper right and lower left corners. Heavily sand then ink the edges of a "Hello Love You" 6x6 paper and a gray texture 6x6 paper. Glue 1/8" from the upper left and lower right corner.
  3. Tear off a 5 1/2" length of heart tape and place 1/4" from top of gray paper. Repeat with lace tape on the "Hello" paper. Tear the right and lower sides of a stripe border text paper layer to create a 3 1/2"x4" paper and glue onto the "Hello" paper. Zot the "ME" Peek-A-Boo label over the paper layer. Zot the "YOU" Peek-A-Boo as shown. Place the "Listen to your Heart" sticker as shown.
  4. Pop out the centers of the Peek-A-Boo filmstrip and back with three 1 5/8"x2 1/8" photos. Zot onto the album at an angle, then Zot on the "&" Peek-A-Boo. Place giant rhinestones as shown.
  5. Using the "Hello Love You" 6x6 paper, cut "Hello Hello" to 5/8"x3" and "Love You" to 5/8"x2 1/2". Sand and ink the edges, then mat each on a 7/8"x4 1/8" black dot paper. Sand the edges and place each over the postholes on the binding, mark the holes and punch. Glue the papers in place. Tear the "You & Me" text from a 6"x6" label paper, ink the edges, and glue on binding, as shown. Add a rhinestone and replace posts and album pages.

Project comments

No one has commented on this project.

 

 

Add a comment

Your name:
Your email address:
(will not be shown)
Your comment:
Security code:

Please enter the word in the picture (click here to see a different word):