Project comments (0) | Write a comment

Pin It


You Can Fly Kite Card

Gail Booth

Save on the products used in this project!

You Can Fly Kite Card
By Gail Booth


Click to Enlarge

Designer Tip: For more vibrant colors, dip the tip of a watercolor pencil in water and apply directly to the edges of your stamped image.

Supplies:

Instructions:

  1. Card front: Place a blank card with the fold on top. Cut a 6½”x5” Mirage black paper. Glue 6”x4½” Mirage teal/yellow tile paper at an angle as shown. Ink the edges of a 6½”x2” Mirage yellow paper black and glue centered on your card. Wrap a length of red swirl ribbon across the yellow strip, gluing the ends under the black paper edges. Glue the constructed piece to the card front.
  2. Stamp the bunny/kite image on 5”x3½” Ultra Smooth cardstock in black. Use the ink blending tool to sponge Splash ink around the outer edges, leaving a white “halo” area around the stamped image.
  3. Color in the image with the watercolor pencils. I used pen numbers #108 & #111 for the kite dots & tail ties, #121 for the kite, #187 for the kite frame, and #234, #273 & #131 for the bunny. Use a wet paintbrush to blend the colors. Let dry, and mat on Mirage black paper with a 1/16" border. Glue on the card at an angle as shown.
  4. Ink the “You Can Fly” Dazzles™ with black StazOn® ink, let dry and place on the lower right corner of the stamped piece.
  5. Place Black Jewel Dazzles™ on the corners of the papers and on the kite tail ties. Tie a length of red swirl ribbon into a bow around the ribbon border on the left side.

Project comments

No one has commented on this project.

 

 

Add a comment

Your name:
Your email address:
(will not be shown)
Your comment:
Security code:

Please enter the word in the picture (click here to see a different word):