Project comments (0) | Write a comment

Blessings Card

LeNae Gerig

Blessings Card
By LeNae Gerig


Click to Enlarge

Designer’s Tip: With just a little trimming you can alter the stem die-cut to work with many different types of flowers.

Supplies:

Instructions:

  1. Card Front: Place the card with the fold at the top and glue 6¼”x4¾” Robin’s Red aqua paper to the center. Die cut the border from red cardstock and glue down the card, ½” from the left. Place Teal Jewel Dazzles™ evenly spaced on the border as shown.
  2. Die cut the Two Oval Doilies & Mats Cutting Dies 4¾” scalloped oval from Robin’s Red ivory paper and ink the edges. Glue ½” from the card right edge. Place Teal Jewel Dazzles™ on the scallops as shown.
  3. Die cut the stem from green cardstock and trim off the 3 lower branches. Cut the stem in half and glue the 2 pieces to the oval as shown. Die cut four leaves from the Chickadee Extras using green cardstock and fold in half. Place foam tape behind the leaves and place on the stems as shown.
  4. Die cut two red cardstock flower centers and four Robin’s Red red dot petals from the Chickadee Extras die. Fold the pieces in half and glue the red dot petals to the outside of the red cardstock centers and foam tape to the top of the stems as shown. Use 1/8” wide red Robin’s Red Ribbon to make a bow and Zot( to the stems as shown. Place “Blessings” Gold Tiny Words & Phrases Dazzles™ on the lower right as shown.

Project comments

No one has commented on this project.

 

 

Add a comment

Your name:
Your email address:
(will not be shown)
Your comment:
Security code:

Please enter the word in the picture (click here to see a different word):