Project comments (0) | Write a comment

Get Well Woven Ribbon Card

Erica Hettwer

Get Well Woven Ribbon Card
By Erica Hettwer


Click to Enlarge

Click to Enlarge

Designer Tip: None

Supplies:

Instructions:

  1. Card Front: Place your card with the fold on the left and cover with Grapefruit light pink paper. Cut a 4 1/2"x6" Grapefruit dark pink paper. Cut three 7" Grapefruit ribbons: 3/4" dark pink crepe, 3/8" polka dot grosgrain ribbon, and 1/2" sheer swirl. Place a Pink Jewel Border Dazzles on the crepe ribbon.
  2. Zot the sheer ribbon 1/4" from the left edge of the paper placing your Zots on the back side of the paper and leaving the front portion of the ribbon loose. Repeat with the crepe ribbon, placing to the right of the sheer. Repeat with the polka dot ribbon, right of the crepe.
  3. Cut two 5 1/2" polka dot ribbons, and two 5 1/2" sheer swirl ribbons and one 5 1/2" crepe ribbon. Place Pink Border Dazzles on the crepe ribbon. Starting 1/2" from the top edge, Zot the left end of the ribbons to the back of the paper in this order: polka dot, sheer, crepe, polka dot and sheer. Weave the ribbons over and under the longer ribbons and Zot to the back side of the paper, making sure to alternate over and under with each new piece. Zot the final end to the back of the panel. Place "Get Well" Dazzles on the bottom right corner of the paper. Foam tape the panel to the card.
  4. Place the teacup Dazzles on a piece of Grapefruit dark pink paper and cut out leaving a 1/16" mat. Place a Pink Jewel Dazzles in the center of the flower and foam tape to the card where the ribbons interweave.
  5. Card Inside: Cut a 3 1/2"x5" Grapefruit dark pink paper and mat on Grapefruit light pink paper with a 1/4" border. Wrap a 5" piece of sheer swirl ribbon 3/4" from bottom edge and Zot the ends to the back. Place "Sending Love" Dazzles as shown. Place flower Dazzles on Grapefruit dark pink paper and cut out leaving a 1/32" mat. Place Pink Jewel Dazzles in the center of the flower and foam tape to the ribbon, 1/4" from the right side. Glue the panel to the center of card.

Project comments

No one has commented on this project.

 

 

Add a comment

Your name:
Your email address:
(will not be shown)
Your comment:
Security code:

Please enter the word in the picture (click here to see a different word):