Project comments (0) | Write a comment

"Adore" glass ornament

LeNae Gerig

Click here to get Love & Adore Ornament Sets.

"Adore" glass ornament
By LeNae Gerig

valentines, ornament, scrapbook supplies
Click to Enlarge

Designer's Tip: Be careful not to use too much ink when covering the inside of the ornament. Too much will make the colors blend too much and take longer to dry. You can always add more ink if you are not satisfied with the results, but cannot take too much away.

Supplies:

Instructions:

  1. Remove the gold hanger cap from the glass ornament. Squeeze a few drops of Currant Alcohol Ink down the inside of the ornament, turning the ornament as the liquid moves down the sides. Repeat until about half of the inside of the ornament is covered. Repeat with drops of Gold Metallic Alcohol Ink. Let the ink dry and replace the hanger cap.
  2. Carefully curve the thin black Banner Greeting Dazzles( hanging strip across one side of the ornament, about 1" from the neck of the ornament. Trim the excess. Place the "Adore" heart Banner Greeting Dazzles(to hang from the thin strip.
  3. Place lengths of the Black Gem Mini Stickers above and below the Banner Greeting Dazzles(. Tie a bow from a 15" length of Gold Memory Thread and coil the ends around a pencil point. Glue to the top of the hanger. Thread the hanger with a 4" length of Gold Memory Thread and twist the ends for a hanger.

Project comments

No one has commented on this project.

 

 

Add a comment

Your name:
Your email address:
(will not be shown)
Your comment:
Security code:

Please enter the word in the picture (click here to see a different word):