Let it Snow Card

Lodell Halvorson

Let it Snow Card
By Lodell Halvorson

Click to Enlarge

Click to Enlarge

Designer's Tip: When coloring Color Me paper, vary the darkness of the ink for added dimension.

Supplies:

• Color Me Sample Pack
• Ocean Fluid Chalk Ink Pad
• Christmas Acrylic Stamps
• Silver Jewel Dazzles™
• Boy Ribbon Set
• Primary Brush Markers
• 12x12 Classic Cardstock
• White Cards & Envelopes
• McGill Ribbon Stitch Punch
• 3-D Foam Squares Variety Pack
• Cosmetic sponges

Instructions:

1. For the card front: Sponge snowflake paper with Ocean ink, leaving centers of the snowflakes white. Place card with fold at the left. Cover with navy blue cardstock. Cut snowflake paper to 6 ¼" x 4 ¾" and glue to the card. Cut out tag and sponge ink around the edges. Mat tag with navy blue cardstock. Cut out single snowflake and ink around the edges. Foam tape over the star on the tag. Stamp "Let it snow" on the tag with Ocean ink and on white cardstock and cut to 1 ¾" x ¼". Glue to the tag. Stamp again with navy marker on white cardstock and cut to 1 ¾" x ¼". Foam tape to the tag. Punch holes and tie bow on the tag. Glue tag to the card. Add jewel Dazzles( to the snowflakes.
2. For the inside of the card: Cut two strips of snowflake paper, one to 5" x 1 ¼" and one to 5" x 1". Glue the smaller piece to the top of the card, and the larger one to the bottom. Cut out three snowflakes and sponge around the edges. Glue to the card, with the largest snowflake in the center.