Designer Tip: When stamping your flower frame place your photo where you want it, and lift before you stamp so that you can get an idea of where to create your frame.
- Background: Cut 11” square from white cardstock. Stamp the flower stamp on a scratch piece of paper. Cut out and save for a mask. Stamp the first flower in the top right corner 1” down from the top. Place mask over the image you just stamped, and stamp with flower stamp letting the edge of the stamp touch the mask while the rest of the image is below the mask. Lift mask and repeat the process until you’ve created a frame around your photo as shown. Glue centered on black cardstock.
- Print “PROM” vertically, cut into a 1¼”x 11” strip and mat onto black cardstock leaving a 1/8” border. Glue vertically 1” from the left. Cut an 11”x2” strip from black cardstock. Using VersaMark™ stamp the flower stamp across the black cardstock. Cover with White Super Fine embossing powder, tap off the excess and heat set. Glue horizontally 1” from the bottom edge.
- Photo: Mat 5”x 7” photo on black cardstock leaving 1/8” borders, and glue in the center of the stamped flower frame. Cut a 1½” square of black cardstock. Cut in half and stamp small flower with VersaMark™. Cover with White Super Fine embossing powder, tap off the excess and heat set. Glue onto the top left corner of the photo, and bottom right corner of the photo.
- Place Rhinestone Eternal Swirls around the photo as shown.