Designer's Tip: When you turn the pinwheel stencil to glitter emboss the next section, you will notice gaps at the ends of each “ray”. When embossed pinwheel is complete, simply cut down the image to remove uneven edges.
- Place the pinwheel stencil square on white cardstock and secure with stencil tape. Apply VersaMark™ directly over stencil openings using stamp pad surface. Remove stencil and sprinkle with red glitter embossing powder, tap off excess and heat with gun. Turn the pinwheel to offset the image and apply VersaMark™ to stencil openings. Remove stencil and sprinkle cardstock with Zing! Black Glitter embossing powder. Tap off excess and heat with gun.
- Cut pinwheel image to 4 1/4” square and mat with white cardstock, leaving 1/8” border. Place the card fold at the top and glue 6 1/4”x 4 3/4” Simply Susan black paper to the card center. Foam tape the pinwheel to the right side of the card as shown. Place a small silver and tiny red hearts from the Mix’ ems Hearts Tri Color Pack to the pinwheel center.
- Place a length of Mix’ ems Hearts Tri Color Pack red heart border down the left side of the card as shown. Cut the top corners from 7/8”x1 1/8” black cardstock to make a tag. Mat with white cardstock, leaving 1/32” borders and place “Love” Dazzles™ from Mix’ ems Hearts Tri Color pack to the tag. Foam tape to the heart border as shown. Use 1/4” wide length of white Metallic ribbon to make a bow and Zot to the tag.
- Inside: Place a 1 1/4”x5” strip of Simply Susan black paper down the card, 1/4” from the right edge. Place a length of silver heart border from Mix’ems Hearts Tri Color Pack down the center of the paper strip. Mat a large red heart with silver heart center and “love” from Mix’ems Hearts Tri Color Pack onto white cardstock, leaving 1/32” border. Foam tape over the border as shown.