Designer Tip: To emboss a 12” length of cardstock, First emboss the top 6”, then align the bottom portion of the lattice image on the cardstock strip with the design on the template and run through machine again to complete the 12” length. You may notice a seam where the lattice image may overlap. This is easily covered with flowers.
- Emboss a 2 3/4”x12” length of Kraft cardstock using the lattice folder. Use the surface of the dark brown inkpad over the raised area of the embossing. Glue 1 1/4” from the left side of the green dot paper.
- Mat 7”x5” photo with white cardstock and emboss 7 3/4’x 5 3/4” yellow cardstock with lattice folder and use to mat photo. Glue photo to extend from under the right edge of the lattice border, 3” from the bottom of the page.
- Trace and cut out large and small flowers from yellow, pink and yellow dot patterned paper and emboss with the Petite Dot folder. Cut out 5 large and 2 small leaves from green textured paper and emboss with Dot folder. Use foam tape to layer the flowers on the lattice border as shown. Place a group of 3 flowers at the bottom right corner of the photo. Place large Jewel Dazzles™ at the flower centers. Place pink Jewel Flower Dazzles™ among the large flowers.
- Write or print on white cardstock and trace with Victorian Label template. Cut out and mat with pink cardstock, leaving a 1/16” border. Glue to extend from under the top right edge of the photo mat. Place large Jewel Dazzles™ on each end of the label. Emboss a small yellow flower and foam tape to the center top of the label. Place a large Jewel at the center.