Designer Tip: All die-cutting machines are a little different. If you are having difficulty getting a clean die-cut image, first place wax paper over the metal die, then run through the die-cutting machine, and back through again. If it is still not a perfect cut, try turning the die and cardstock sideways and run through machine again.
- Cut a 3 7/8” scallop circle from black cardstock. Cut a 3 1/4” circle from Happy Days green circle paper, ink edges and glue to the center of the scallop circle.
- Fold 3”x6” Kraft cardstock in half with short sides together. Place the 2 1/2” Die to extend off the edge of the fold by 1/8” and cut through both layers of cardstock to create a circle card with a flat edge fold at the top. Place a 3”x 1 5/8” Happy Days yellow circle paper across the center of the 2 1/4” die and cut to round the sides. Glue across the center of the card and ink the edges black. Glue the card to the center of the green dot circle.
- Place a small bike Dazzlesä on the yellow circle strip. Back a gift Dazzlesä with Happy Days orange dot paper and Kraft cardstock for the tag. Glue to the back of the bike. Place “Enjoy” Dazzlesä on bottom of circle card as shown. Tie the ends of 6” length of Happy Days orange grid ribbon and Zotä to the top of the circle card fold. Use a 9” length of 1/2” wide Happy Days yellow dot ribbon to make a bow and Zotä over the grid ribbon.
- Inside: Back balloon Dazzles™ with Happy Days orange and Happy Days yellow circle paper and glue to the inside back of the circle card. Place “Happy Birthday” Dazzles™ on the inside of the card front.