Designer Tip: All die-cutting machines are a little different. If you are having difficulty getting a clean die-cut image, first place wax paper over the metal die, then run through the die-cutting machine and back through again. If it is still not a perfect cut, try turning the die and cardstock sideways and run through machine again.
- Card Front: Place the card fold on the left and cover with black cardstock. Glue 4 3/4”x3 1/2” Rosemary & Thyme ivory/black houndstooth paper to the card top and 4 3/4”x2 1/2” Rosemary & Thyme pink tile paper at the bottom. Glue 4 3/4” x1/4” black cardstock strip across the seam between papers.
- Mat 2 1/4”x5” Rosemary & Thyme pink dot paper with black cardstock, leaving 1/8” border and glue 3/4” from the left and 5/8” from the top. Stamp the large circle stamp on Rosemary & Thyme ivory flourish paper. Stamp a greeting at the center. Cut out using the 3 1/4” circle die and glue overlapping the right edge of the pink dot border.
- Die cut a 1 7/8” circle from Rosemary & Thyme black dot and 1 1/4” circle from Rosemary & Thyme houndstooth paper. Foam tape both on the bottom left of the large circle. Zot™ a bow between the two small circles as shown. Place an acrylic flower above the bow and 3 at the top right of the large circle. Place Jewel Dazzles™ in the centers.
- Inside: Ink the edges of 3 1/2”x6” Rosemary & Thyme pink tile paper and glue 1/4” from the card fold. Mat 3 1/2”x4” Rosemary & Thyme pink dot paper with black cardstock, leaving 1/8” border. Glue to the card center, 1” from the card top. Stamp the 1 5/8” circle onto Rosemary & Thyme ivory flourish paper and die cut with the 1 7/8” circle. Glue to the center top of the pink dot paper. Glue and foam tape two 1 1/4” circles below as shown. Glue a flower as shown and place a black jewel Dazzles™ in the center.