Designer's Tip: Emboss your die-cuts with Zing! glitter embossing powder for a stunning focal!
- Use VersaMark™ to stamp a fairy on the center of a 3”x4 3/4” tag, and “Wish BIG” on the upper left corner. Dust with Silver Zing! embossing powder and use the heat gun to set.
- Follow your die cutting machine manufacturer’s instructions to cut three flower die-cuts from swirls vellum. Zot™ the flowers onto the lower right corner of the tag.
- TECHNIQUE: VELLUM & SILVER ROSES Cut three flower die-cuts from white cardstock. Ink the die-cuts with VersaMark™, dust with embossing powder and heat set. Glue onto vellum and cut out along the outer edges of the die-cuts. Zot™ two flowers in place on the tag, and foam tape the third on the corner, overlapping the other two flowers.
- Thread two 7” lengths of red dotted sheer ribbon through the tag hole and tie together with red glimmer ribbon.