Instructions:
- Place your laser card so the fold is on the left. Cut two 5/8"x5"red dot strips and ink the edges. Glue 1/8" from the top and bottom edges.
- Glue ribbon along the paper edge as shown. Weave a 2 1/8" long ribbon through the present section of the laser design, glue and trim even with the edge of the present. Write "Happy Birthday" below the present.
- Inside the card: Ink the edges of a 4"x5" piece of red cardstock and glue centered on the inside. Fold a 6"x3" red dot in half to make a small card, then cover the inside with red cardstock. Ink the inside and outside edges.
- Write on a 2¼"x2"white cardstock, ink the edges and glue centered on the inside. Mat the small card on white cardstock with 1/15" borders. Glue centered on the card inside.
|
|
