Let it snow!
Designer: Susan Cobb |
Click to view large image
|
Click to view large image
|
Instructions:
- Cut a 3 1/2" square from the foil cardstock and attach behind of the snowman laser design, on the inside back. Glue a 5" 3/4" strip of foil cardstock across the front, 7/8" from the bottom of the card. Stamp "Let it Snow!" above the laser design. Stamp small snowflakes around the words at the top of the card, and across the bottom as shown. Zot ribbon near lower right corner of laser design.
- Inside the card: Glue a 3 1/2" foil cardstock square centered on the inside. Stamp the "Celebrate White Christmas" circle on the center of a 2 1/4" white square. Stamp small snowflakes across the top and bottom of the square. Fold a 1 1/2" length of ribbon and glue to the back so it extends for a tab. Glue centered on the foil cardstock.
|
|
Supplies:
|
| |