Ribbon Edge Diarama Card

LeNae Gerig

Ribbon Edge Diorama Card
By LeNae Gerig

Click to Enlarge

Designer’s Tip: To shape the die-cut flowers, place then on the foam mouse pad and use the large stylus from the kit to press down in a circular motion. This makes the flower edges curl upward slightly. Glue as the top layer on the card topper.



  1. Punch out the front and back acetate sections, removing the center piece from the window and the pre-punched holes.
  2. Fold the score lines on the acetate piece, starting with a valley fold, then a mountain fold, and then a valley fold, creating a zigzag.
  3. Slide the punched out card back between the back folds on the back of the acetate, making sure that you leave the foiled side outwards for writing your message.
  4. Position the front acetate on top, lining up the holes, and thread the white 1/8” wide ribbon (included in the kit) through them, tying with a knot or bow as shown.
  5. Punch out the coordinating 3-D pieces, shape the top layers of flowers with the large stylus from the tool kit and foam tape then to the card front topper sheet.
  6. Slide the card back die-cut from the acetate diarama. Foam tape the card topper to the center of the topper back piece with the die-cut frame taped around the outside edge. Slide back into the acetate diarama. Foam tape the circle die-cut greeting to the acetate front as shown.