Hello Card

Susan Cobb

Hello Card
By Susan Cobb

Click to Enlarge

Designer Tip: 1) Place your card with the fold at the left and cover with Picket Fence lavender script paper and ink the edges black. Cut a 4 1/2"x6 1/2" Picket Fence lavender dots paper and ink the edges. Glue it centered down the card. 2) Cut a 4 1/4"x6 1/2" double-sided adhesive. Peel off one side of the backing, place it on white cardstock, and trim the cardstock edges evenly. Peel the remaining backing from the adhesive. Carefully place the wide lace centered down the adhesive and press in place (if you have a plastic page protector, it is helpful to place it on top and press the lace down well, then remove the plastic; this will help keep the adhesive clean). 3) Sprinkle the lace/adhesive with basic black microfine glitter and burnish it well into the adhesive. Tap off the excess and burnish it again. Repeat until no more glitter taps off. 4) Carefully pull up the lace from the adhesive and set it aside. Sprinkle with Lavender glitter and burnish it well and tap off the excess as you did in step 2. Glue the glittered lace motif centered down the card on the lavender dots paper. 5) Use the Botanical Blooms Cutting Dies and your die cutting machine to cut 1 stem of leaves/flowers each from Picket Fence lavender script paper and Picket Fence green script paper. Glue the green stem with leaves and flowers centered on the glittered adhesive. Trim the blossoms from the lavender die cut and foam tape the pieces onto the green stem as shown. 6) Place Silver Tiny Words & Phrases Dazzles "Hello" to the left of the flowers as shown. Use 3/4" wide lavender crepe ribbon to tie a bow. Zot as shown.