Bunny Easel Card

LeNae Gerig

Bunny Easel Card
By LeNae Gerig

Click to Enlarge

Designer Tip: Cut the card to 5" square and place the fold on the top. Open card and fold top edge to the center fold. Close card and glue matted 4 " red striped Charming paper to the lower portion of the fold on the card front. Mat 3 " square of green Charming paper with black cardstock, leaving 1/8" border and glue to the card center. Ink edges of 1" wide strip paper and glue across the card center. Stamp bunny image onto white cardstock and color face, paws and ears with light and dark gray Spectrum Noir pens. Color cheeks, cuffs and feet with peach pens. Use Spectrum Noir Blender pen to remove color from muzzle areas. Color pants and tail piece aqua. Color edges of tail with gray and soften color with Blender pen. Cut out bunny body, leaving 1/16" and glue the card center. Die cut the tail oval and place on the Action Wobble piece and adhere to the bunny as shown. Tie a crepe bow and Zot to the card top left corner. Inside: Glue 7/8" wide strip of green stripe paper 1 3/8" from the card bottom. Foam tape a matted stamped rectangle with greeting and place on border. Prop the card front behind the greeting.