Let Your Dreams Soar Tag
By Debbie Samples
Designer Tip: The gold metallic color makes the tag rich.
- Cut a 3”x5¼”Charleston black border paper, with the border at the bottom. Mat on black cardstock with 1/8” borders. Wrap a 4”x2” Charleston yellow paper around the tag 2” from the bottom.
- Cut a 4¼”x4¼” gold metallic Shrink Film. Ink the tree stamp with StazOn ink. Stamp centered on the shrink film. Let dry. Use the Permanent Black Marker to draw a line ¼” from each edge. Place the shrink film on a cutting board, or piece of cardboard. (the heat tool can ruin the finish of furniture) Begin heating with the heat tool, trying to wave evenly over the entire piece. The shrink film will begin to curl and shrink. If an edge gets stuck, gently pull apart, and continue to heat. When it flattens out again, place a flat smooth tool such as your acrylic block on the heated piece to completely flatten it. When cool, Glue centered on a 2¼” piece of black cardstock, placed on point. Glue on the yellow band on the tag. Place Dazzles™ as shown.
- Stamp the sentiment on Charleston yellow paper in StazOn ink. Mat on black cardstock with 1/16” borders. Foam tape on the bottom right corner.
- Punch a hole at the top, and knot three ribbons through the hole..