“Thanks” Card

Susan Cobb

“Thanks” Card
By Susan Cobb

Click to Enlarge

Designer Tip: 1) Cut a 5”x7” piece of Triple Finish gold mirror sheet and place it face up inside the embossing folder. Emboss in your die cutting/embossing machine. Now place a 1 1/2"x7” piece of Triple Finish brushed gold sheet face down inside the middle of the embossing folder. Pull it through your machine. The brushed gold piece will be a debossed image. Cover the left side of your card with the brushed gold piece and the right side with the embossed mirror piece. 2) For the butterfly die cuts: triple fold a 6” piece of cardstock into a narrow rectangle about 2” wide. Place it below the Precision Base Plate in the sandwich for your Die Cutting/Embossing Machine. Place the Triple Finish gold mirror material face up, then the butterfly cutting die face down on top. Add the clear plate and run it through your machine. Repeat for the glitter and brushed gold finishes. Die cut the shadows from black cardstock and layer as shown.