Just For You Card
By Debbie Samples
Designer Tip: If you use a mask, you can get an even different look for your stamps.
- Card front: Place a blank card with the fold on top. Cover with Blue Glimmer Paper. Trace and cut a Design Tool Kit Cover piece from Indigo Lace bue/tan tile paper. Place the piece on the card front, 1/8” from the fold. Cut around the piece, leaving a 1/8” border, and leaving the fold intact at the top corners of the card. Leave ¾” spaces on each side at the fold.
- TECHNIQUE: Masking images to overlap. Trace and cut a Bracket Label from Lapiz Lazul glimmer paper. Stamp the long flower sprig, in VersaMark™ ink, ½” from the right, and ½” from the bottom. Dust with silver embossing powder. Tap off the excess. Heat with the heat tool. Stamp the same image in black ink on a scratch paper. Cut close to the stamped image. Place this mask over the first image. Ink the banner label stamp with VersaMark ink™. Stamp so the bottom right corner overlaps the covered first image. Dust with silver embossing powder. Tap off the excess, and heat with the heat tool. Stamp and heat emboss the words in the center of the banner. Mat on silver metallic paper, with 1/8” borders. Foam tape centered on the card front.
- Card inside: Trace and cut a Double Bracket Label from Lapiz Lazul glimmer paper. Stamp the sentiment in VersaMark™ ink. Heat emboss with silver embossing powder. Stamp the flower and butterfly as shown. Heat emboss with silver embossing powder. Mat on a Decorative Label cut from Indigo Lace blue/gray tile paper. Glue centered.