50/50 Fridays: 50 items at 50% off beginning each Friday for one week. What will they be?

Project comments (0) | Write a comment

Pin It

Merry Christmas Snowflake

Amy Hurley-Purdie

Save on the products used in this project!

Merry Christmas Snowflake
By Amy Hurley-Purdie

Click to Enlarge

Designer Tip: Use a piece of wax paper over your cutting die for an easier release. Make sure to pick out any left over pieces of paper that might have stuck to cutting die.



  1. Open card horizontally. Trim to 5 1/2" x 10". Place on to Pop-Up Snowflake Cutting Die making sure fold is lined up with score. Cut and set aside. Cut 5 1/8"x10" Blue Snowflakes Holographic paper. Place on to Pop-Up Snowflake Cutting Die, making sure fold is lined up with score. After die cutting, remove snowflake leaving only negative image in card. Cut just the snowflake from white cardstock. Cut in half and set aside. Cut white cardstock with Merry Christmas Cutting Die Set, set aside.
  2. Glue Blue Snowflakes Holographic paper flush with top and bottom leaving 1/8" border on left and right sides. Take cut snowflake and place in top left corner, and bottom right corner, as shown. Place Silver Jewel Dazzles scattered around snowflake.
  3. Add Silver Jewel Border Dazzles around the edges of the Blue Snowflakes Holographic paper. Take smallest Silver Jewel Border Dazzles and place on to center snowflake as shown. Glue "Merry Christmas" diagonally inside of card as shown. Add Silver Jewel Dazzles to dot the "I" in Christmas.

Project comments

No one has commented on this project.



Add a comment

Your name:
Your email address:
(will not be shown)
Your comment:
Security code:

Please enter the word in the picture (click here to see a different word):