Project comments (0) | Write a comment

Pin It

For You Easel Card

LeNae Gerig

Save on the products used in this project!

For You Easel Card
By LeNae Gerig

Click to Enlarge

Click to Enlarge

Designer’s Tip: Fold Hunkydory printed cardstock into an easel card and embellish with card toppers!



  1. Cut the rust grid and brown border cardstock to 5”x10 1/8”. Place the border at the top and turn the cardstock over to the white side and fold in half, short sides together and use bone folder to score. Fold the card top in half again.
  2. Close the card and center the hedgehog on the front. Foam tape the bottom half of the card topper only to the bottom half of the folded card.
  3. Inside: Glue 5”x2 1/8” rust grid cardstock across the bottom of the card. Glue a length of die-cut border across the card, ¾” from the bottom. Foam tape a square die-cut greeting to the center of the border, ¼” from the card bottom.
  4. Slide the card front behind the foam taped greeting to stand upright. Foam tape small square die-cut greetings extending off the card edges at the top and bottom as shown. Use a length of 1/2” wide gold organdy swirl Heritage ribbon to make a bow and Zot( below the hedgehog card topper.

Project comments

No one has commented on this project.



Add a comment

Your name:
Your email address:
(will not be shown)
Your comment:
Security code:

Please enter the word in the picture (click here to see a different word):