Project comments (0) | Write a comment

Pin It

To Someone Very Special

LeNae Gerig

Save on the products used in this project!

To Someone Very Special
By LeNae Gerig

Click to Enlarge

Designer's Tip: Use a sanding block or emery board to lightly sand tabs off die cut edges.



  1. Follow the card kit instructions to fold the Outer Card Section along the fold lines to make mountain and valley folds.
  2. Fold the Inner Card Section with opposite folds as the Outer Card Section, valley and then mountain. Use double sided tape, Click 'n Stick Mounting Squares to adhere the foiled panel sections and greeting to the folded Card Sections.
  3. Foam tape the Lady Topper to the card front section so that it overlaps the valley fold. Foam tape the "To Someone Very Special" foil greeting to the bottom left corner. Use Confetti Ribbon Set 1/8" wide purple grosgrain ribbon to make 2 bows and Zot( one to the card front and one to center greeting as shown.
  4. Fold card down to place in included envelope.

Project comments

No one has commented on this project.



Add a comment

Your name:
Your email address:
(will not be shown)
Your comment:
Security code:

Please enter the word in the picture (click here to see a different word):