Project comments (0) | Write a comment
With Love Heart Card
![]() |
|
Gail Booth |
With Love Heart Card
By Gail Booth
![]() Click to Enlarge |
![]() Click to Enlarge |
Designer Tip: Run the acetate under water and blot dry with a paper towel before embossing to reduce static.
Supplies:
- Roses & Lace Double-Sided Scrapbooking Papers
- Roses & Lace Ribbon Set
- Lacy Things Stamp Set
- Heat Resistant Acetate
- Burgundy Suede
- 8 Circles and Scallops Cutting Dies
- Platinum Jewel Border Dazzles™
- 4"x6" Acrylic Block
- Metallic Gold Rich Super-Fine WOW! Embossing Powder
- VersaMark Watermark Stamp Pad
- StazOn Ink Pad, Timber Brown
- White Cards & Envelopes
- 1/4" Ultra Clear Tape
- Foam Tape
- 2 Photo Glue Sticks
- Heat Gun
- Powder Blue BigShot Die Cutting Machine
- Deluxe Embossing Tool & Stylus
- Cosmetic Wedge
Instructions:
- Card front: Place a blank card with the fold on top and cover with Roses & Lace gray rose border paper, keeping the roses on the right side. Use the wedge to ink the edges with Timber Brown StazOn® ink.
- Use VersaMark™ to stamp a small butterfly at the top right corner of 3 ¾”x3 ¾” sage green lace paper. Dust with gold embossing powder, shake off excess and set with the heat gun. Stamp and emboss a medium rose on the opposite corner, and a small flourish going off the remaining corners. Cut the piece in half vertically, then each in half horizontally, creating four 1 7/8”x1 7/8” pieces. Ink the edges of each piece, mat each on burgundy suede with 1/16” borders and glue ¼” apart from each other, 3/8” from the top, left and bottom edges of your card, as shown. Place Jewel Dazzles™ on the corners opposite to the embossing.
- Use the cutting dies to cut a 3 ¼” circle from burgundy lace paper, ink the edges, mat on suede with a 1/16” border and glue centered over the four squares.
- Set a 6 ½”x5 ½” acetate over the card front, aligning the bottom edge. Stamp the large heart and “With Love” over the burgundy circle, as shown. Remove from the card front, dust with embossing powder and heat set. Swipe the bottom corners with the VersaMark™ ink pad, and emboss.
- Score a horizontal line ½” from the top edge of the acetate, mountain fold the tab to the back and use Ultra Tape to attach the tab to the card back, along the fold. Place Jewel Dazzles™ on the heart swirls. Fold a length of 1 ½” burgundy crepe in half to make ¾” wide, then tie in a bow and Zot™ below the embossed heart, as shown.
Project comments
No one has commented on this project.
Add a comment