Monday Madness: Flash Sale every Monday! Great bargains, always changing!

Project comments (1) | Write a comment

Pin It


Hello Card

LeNae Gerig

Save on the products used in this project!

Hello Card
By LeNae Gerig


Click to Enlarge

Click to Enlarge

Designer’s Tip: Use an X-acto® knife to pick up and place tiny Dazzles™ innie pieces to fill in the butterfly design.

Supplies:

Instructions:

  1. Front: Cover the card front flap only with Darkroom black text paper and cut around the butterfly wing with small scissors. Tear ½” wide strip of gold diamond paper and ink the torn edge. Glue along the left edge of the card front.
  2. Place the butterfly Dazzles™ black/gold wings outline on the die-cut butterfly window. Fill in wing outline with Dazzles™ innies from black and the gold butterfly Dazzles™ as shown. Foam tape the butterfly window die-cut over the die-cut card. Place one black/gold Dazzles™ antenna on the card front as shown.
  3. Inside: Cover the card inside back with Darkroom gold diamond paper. Ink card edges. Cover the die-cut butterfly with black/brown paper and glue to the inside card back, aligning with the inside of the butterfly on the card front. Place pearl gold butterfly Dazzles™ wings on the die-cut and fill in the black butterfly Dazzles™ innies. Place 2 black Dazzles™ antenna above the butterfly. Place “Hello” on the bottom right corner.

Project comments

Written by sally
 2 years 12 months ago:
all the cards you make are my favorites. Keep up the good work.serious

 

Add a comment

Your name:
Your email address:
(will not be shown)
Your comment:
Security code:

Please enter the word in the picture (click here to see a different word):