Project comments (0) | Write a comment

Pin It


Adventure Card

LeNae Gerig

Save on the products used in this project!

Adventure Card
By LeNae Gerig


Click to Enlarge

Designer's Tip: Place the card fold on the side and cover with Trail Blazer border paper with the border on the bottom. Glue and foam tape 1 7/8" wide squares of tan map and aqua paper on green paper, leaving a 1/8" wide border. Glue near the top of the card, as shown. Place Lumber Jack Dazzles, on the squares, backing some with tan paper if needed. Place "Adventure" saw Dazzles along the border. Use a length of Trail Blazer 1/8" wide rust ribbon to make a bow and Zot to the card as shown.

Supplies:

Project comments

No one has commented on this project.

 

 

Add a comment

Your name:
Your email address:
(will not be shown)
Your comment:
Security code:

Please enter the word in the picture (click here to see a different word):