|
Airbrushed Love Card
By: Gail Booth
|

Click to view large image
|
|
Designer Tip: Remember to remove the airbrush pen holder insert to fit Spectrum Noir™ pens in the barrel. Test the spray pattern on scrap paper and adjust the pen to get the best spray intensity.
Instructions:
- Tape the stencil over 4¾”x4¾” white cardstock. Place pen #DR1 (reds set) in the airbrush pen barrel and spray randomly through the cardstock, leaving white areas. Use pen #CT4 (yellows set) in the airbrush to fill in the remaining areas, allowing the two colors to blend in between. Remove the stencil and run the broad tip of pen #DR1 around the edges of the cardstock.
- Card front: Glue the airbrushed piece 1/8” from the top and sides of 5”x6½” black cardstock. Wrap sheer pink swirl ribbon around the cardstock, 2” from the bottom, tying a bow on the left. Place a blank card with the fold on the left and glue the piece centered on the front.
- Following the manufacturer’s instructions of your die cutting machine, die cut a plain heart from silver metallic paper and mat on black cardstock with a 1/16” border. Die-cut a swirly heart and “Love” from silver pearl self-adhesive sheet. Remove the adhesive backing from the silver pearl heart, center over the silver metallic heart and glue in place next to the bow, as shown. Remove the backing from the “Love” die-cut and place as shown.
|
|
Supplies: (Find these supplies and more at www.paperwishes.com)
- Love & Five Hearts Cutting Dies (link)
- All Over Swirls Stencil (link)
- 5”x6 1/2” Blank White Card (link)
- Silver Metallic Specialty Paper (link)
- Classic Organdy Swirl Ribbon Set (link)
- Six Pearl Sheets (link)
- White Cardstock (link)
- Classic Cardstock (link)
- Reds Spectrum Noir™ Pen Set (link)
- Yellows Spectrum Noir™ Pen Set (link)
- Perfect Airbrush (link)
- Zots™ Adhesive Dots (link)
- Glue Stick (link)
- Stencil Tape (link)
- Craft Sheet (link)
|
|
|
|
|