|
Lacy Purple Thank You Card
By: Teresa Welch
|

Click to view large image
|

Click to view large image
|
Instructions:
- For the card front: Turn the card with the fold at the top. Cut 6¼"x4¾" Jewel purple ferns paper and stamp the ½" wide lace across the lower edge. Sprinkle embossing powder on it, tap off the excess, and heat with the gun to melt the powder. Glue centered on the card. Cut a 2½"x2" Jewel blue words paper and a 2¾"x3¾" Jewel blue flowered paper. Emboss the same lace along the lower edge on the small piece and the left edge on the large piece. Mat each on white paper with 1/32" borders and glue as shown.
- Cut a 6¼"x1" Jewel purple flowered paper and mat the long edges on white paper with 1/32" borders. Emboss the 2¾"x1" lace motif just slightly left of center. Emboss a ¼" lace border on each end. Emboss the lace circle and the ½" flower on the white disk. Use purple sheer ribbon to tie the disk onto the border just right of the motif, then glue the border to the front as shown.
- Cut out the smaller 3-D lily from Jewel purple textured paper, curl the petals under, and glue to create the 3-D shape. Cut the smallest lily from Jewel purple paper and glue to the lily center. Insert a white brad in the center, then glue over the ribbon above the disk. Place the Dazzles™ as shown.
- For the inside: Cut a 4½"x3" Jewel purple floral paper and emboss the lace motif near the left edge. Glue ¾" from the lower edge. Cut out the “thank you” acetate and glue the upper edge to the purple paper. Cut a 6½"x1½" Jewel blue flowered paper and mat the lower edge on Jewel black glimmer paper with a 1/32" border. Emboss the ½" lace ¾" from the upper edge. Wrap and tie purple sheer ribbon around the right end, then glue the border as shown, covering the glue on the acetate. Place the Dazzles™ as shown.
|
|
Supplies: (Find these supplies and more at www.paperwishes.com)
- Jewel Cardmaking (link)
- White paper
- Lace & Doilies stamp set (link)
- Purple Flower Jewel Dazzles™ (link)
- Silver Jewel Dazzles™ (link)
- Watermark ink pad (link)
- Black Super Fine embossing powder (link)
- Heat Gun (link)
- Adhesive (link)
- 5"x6½" blank white card (link)
|
|
|
|