|Life is good Card
By Debbie Samples
Designer Tips: Cover a blank card with Black Suede paper. Place the Filigree cutting die at an angle, so it is about 1½” from the corner on each side of the card, and cut through the front only. Cut a 6¼”x 4¾” Darkroom yellow paper. Use the largest cutting die on the corners, at an angle about 1½” on each side from the corner. Glue centered, matching the corners with the black suede. Use the Filigree cutting die and the largest cutting to cut a black suede piece. Use the largest cutting die to cut a Brown Fireworks Holographic paper. Back the black suede with the holographic paper. Glue vertically to the card front centered.
Stamp on Darkroom yellow paper with VersaMark™ ink. Dust with black embossing powder, and tap off the excess. Heat with the heat gun. Use the matching cutting die to cut out the stamped image. Foam tape to the center of the black suede. Place the Dazzles™ as shown.
Inside: Glue a 6½”x2” Brown Fireworks Holographic paper on the bottom edge. Cut a 6¼”x4¾” Dark room green paper. Cut the corners as in step #1 with the largest cutting die. (so it does not show through the front) Glue centered. Use the Filigree cutting die and the largest cutting die to cut a Brown Fireworks Holographic paper. Use the smaller dotted cutting die to cut the middle from the holographic piece. Use the largest cutting die to cut a Black Suede paper. Back the Holographic Filigree with the black suede. Glue horizontally centered. Use the dotted cutting die to cut a Darkroom yellow paper. Cut off the dots. Glue to the center of the holographic paper. Place the Dazzles™ as shown.