3-D Ornaments By Gail Booth |
|
![]() Click to view large image |
|
Designer Tip: Use the precision base plate as the lower plate of your die-cutting sandwich and the 3-D cutting die from each set (the cutting die with nested shapes in the center) to cut a 3-D ornament die-cut from a metal sheet, being sure to have the cutting die . Place an outer star and a star outline nested together, cutting side down on the front of Silver Fireworks paper and tape in place. Place cutting side down on the precision base plate with your acrylic cutting plate on top and run through your die-cutting machine. Repeat the process on the back of Silver Fireworks paper to get two die-cuts that will match when placed back to back. Sandwich the metal 3-D star ornament between the Silver Fireworks frames, attaching with Zots™. Place blue bling on the front and back, tie a loop of blue ribbon through the hanger and Zot™ on a bow, as shown. Repeat the same process for the wreath ornament, using Green Circles paper, red bling and a red ribbon. Supplies:
|
|